Getting Started with the Mini-Rocketbox Pre-Roll Machine

The Mini-Rocketbox is preferred by processors and dispensaries for its compact size, durability, and pre-roll filling efficiency. The Mini securely fits on any flat tabletop surface by adhering with a heavy-duty suction cup. With the ability to fill and pack 143 joints in each cycle, the Mini-Rocketbox is certain to increase productivity and save money on labor costs. 

Operating the Mini-Rocketbox properly is pivotal to ensure a smooth, consistent fill. Before starting, check your surroundings and remove any objects on the same table as the machine. The intense vibrations may cause objects in the same workspace to shift and move.

Placement of the Mini-Rocketbox

Avoid placing the Mini-Rocketbox pre-roll machine in the middle of a table. The vibrations will reverberate back through the four legs of the machine, causing inconsistencies with filling and packing. It’s recommended to place the machine on the side of a table as it’s sturdier, less flexible, and focuses the vibrations to the inside of the machine.

Leveling Creates Consistency

Verify that the Mini-Rocketbox is level with a leveling tool. This will ensure that the product is moving evenly across the top of the machine. If the machine is sloped in any direction, your material will move in the same direction, potentially causing weight inconsistencies with the pre-rolls.

Fill with Pre-Rolled Cones

After you’ve properly placed and leveled the Mini-Rocketbox, you can begin filling the bottom tray with cones. All pre-rolled cones should be sitting at roughly the same height throughout the tray. Keep in mind that cones will sit differently depending on the size of the tray used.

Optimal Vibration Frequencies for Packing Pre-Rolls

Turn on your Mini-Rocketbox, we recommend starting on high power. In this range, the machine vibrates just like the RocketBox and achieves a pack with the most optimal amount of vibration. Notice the low-frequency sound produced when the dial is turned in between “I” and “G” in “HIGH”. A higher-pitched frequency will be heard once Max Speed is achieved.

TIP: The machine will not vibrate the same without the Top Tray and Bottom Tray screwed down into the machine. When testing placement and vibration, be sure to test with the Top Tray and Bottom Tray together, with the washers and wing nuts fully secure. This will allow for optimal vibration research and development prior to filling and running the machine.

For additional questions and concerns relating to your Mini-Rocketbox, please reach out to us at clientservices@stmcanna.com or give us a call at (509) 204-3148.